Hi Folks,

I am looking for advice on various repair kits and equipment needed to repair the hashboards. The T17 and S17 miners are not as reliable so looking specifically for those. I have looked into Zeus mining gear in the past and looks very makeshift.

Is there something better out there in terms of speed, quality, performance and support? Thanks in advance.

Hi Folks,

Is there a way to run the A1047 efficiently? Wondering if there are any improvement softwares like Braiins or Vnish for these?

Hi Folks,

Has anyone noticed issues with S17 Pro psu's. I have a bunch which have gone bad lately. Wondering if others are facing similar issues?

[xxx123abc]

Trying to find a post and person I used to follow for technical analysis.
There was this guy with a username something similar to xxx123abc
He started accurately speculating in December 2017 that the market will hit around 4K and nobody believed him.

Would anyone know where his OP are? I know he still posts it but I just lost my bookmark and cant find it. 

I have some miners which keep going back to default after few hours of mining. Anyone had such an issue? What can be the reason? Thanks.

Hi Folks,

Is there a guide or a post where I can get some coaching on how to read the kernel log to figure out the issues? Thanks.

Hi Folks,

Just wondering what fans do the pro miners use when the fans on the S9 die? Don't have that issue yet but want to be prepared. Thanks.

Hi Folks,

I am wondering what is the highest operating temperatures the S9 antminers can withstand during the summer time? Thanks.

Hi Folks,

Can you please provide good sources to find used and cost effective Power Distribution Units (PDU's)? Thanks.

Hi Folks, has anyone faced an issue where the green light on the miner becomes solid? I have tried rebooting the miner quite a few times... hot and cold boot both but it stays solid green. What can be the problem? Thanks

Hi Folks,

Is anyone running their S9's at more than 240 Volts or tried it? What was your experience? How far can it go over 240 volts? Thanks.

Hi Folks...Has anyone figured out an easy way to keep the transaction fees and not pay 4% to antpool? I know that mining with Antpool you don't get the transaction fees. But how is everyones experience mining with pools like Kanopool and BCMonster? Thanks.

Hi Folks...Can someone please educate me what is merged mining? I understand that it is mining 2 coins at the same time. Antpool gives that option with Bitcoin mining. Is anyone doing merged mining with S9's?

Please provide your valuable feedback. Thanks.

Hi Folks...

Do you have any recommendation on what kind of filters I can put on my intake louvers to keep the dust and rain out? Thank you.

Hi Folks...the 3rd pool in miner configuration on many of my miners is showing up as "dead". Does anyone know the reason behind it? Is it some setting in the router? Please guide and assist. Thank you

Hi Folks...what happens in a scenario where there is more exhaust than needed? Is it bad for the miners? Thanks.

Hi Folks...do you have any good source to buy CAT 6E network cables? Thank you.

Hi Folks,

Most of my plugs or say all of them are set up on a 20 amp breaker with 2 receptacles on each for a total of 1.5 KW x 2 S9 antminers energy consumption. If I have some low power consumption machines say 800 watts. Do you think I can use the below splitter cable to split each plug in 2? Let me know your thoughts... Thanks.


https://www.pduwhips.com/products/2127-6-20p-to-c13-y-splitter-power-cables.aspx

Hi Folks, should I go for unmanaged, managed or smart switches for 500 some miners? Thanks.

Hi Folks...

Looking to get some ideas on exhausting the hot air out, best practices on exhaust and ventilation and the equipment successful miners have used to exhaust the hot air out. Thank you in advance