Hello Guys,

Hope you are doing well. Can you please clear my doubts?

What is the recommended temperature for PCB & Chip for Antminer? Is it the same temperature for all Antminer models?

Recently, I purchased 2 units for T17+ 64TH

I use Awesomeminer for remote monitoring. Awesome miner shows me both PCB & Chip temperatures

it shows highest PCB temperature as 51C, and that miner shows Chip temperature as 78C





According to Awesomeminer, if chip temperature goes 80C or above, then it turns yellow

Does it mean that going 80C or above for chip temperature is dangerous?

Also, do you think the miner firmware is reliable? because I had experience with Antminer S9 model in the past where the hash board got fried, and the status page was showing 200C for the board
I think it was my mistake that I replaced the miner fan with another fan to lower noise level, when I woke up the next day, the fan was not spinning, but the firmware should have stopped mining once 80C was crossed right? I feel there is a delay for between temperature check, and fan RPM adjustment, and by the time firmware checks the temperature, then it is game over for the hash board before adjusting fan RPM.