I have 4 block erupter cubes and all was well and good until I recently re-installed windows on a new system. Now I can't get to the config page at all, I tried the default 192.168.1.254:8000 and what I changed them to 192.168.1.200-203. I didn't have to change any router settings previously, but now i have gone in and enabled dhcp range to 192.168.1.100-254 still no luck.
I have been working on them all day, to no avail and I'm out of ideas...
I installed the bridge driver for them, I can see them when i connect them to my computer and which com port they are on. Though when I access my modem, i only see the 2 computers that are on this router, i don't see any cubes...
I will give a .10BTC reward for whoever can help me solve this issue.

I have tried hitting the factory reset button, didn't change anything.
My setup is DSL modem/router to a tp-link router, the DSL modem gateway is 192.168.0.x, but I have my tp-link router set 192.168.1.x. I would think since these all talk via the tp-link router, they would be operating on the 192.168.1.x like they should be, I just don't see them anywhere on the network...