Show Posts
|
Pages: [1]
|
I currently have one Bitmain X5 but the machine is crippled to monero only. Are there currently some development for an alternative firmware for it. Any info or teams working on it. Every info is welcome. Best regards
Arthur
|
|
|
I have a problem with 2 s17+ hashboards having this error. I have medium knowledge and can repair 60% of all the s17+ i see my eyes on. This one drives me crazy because i tried everything what i know off.
I replaced chip 64 and 65 3 times and chips 63 one time. RO signal is 1,8 volt and the clk signal is ok with 0,9 volt. All normal values as i know.
I replaced the voltage regulator and little part around chip 65 as a last measure. No result. Anyone has a tip or advice what to do?
|
|
|
Question guys, i am looking for a way to memory upgrade the Innocilicon A10 Eth miners. Current memory on the sold A10 Eth miners till March 2020 is 4 GB In September the Etc dagger file will bw bigger then 4 GB and 3 weeks later the Eth dagger file have the same situation. This means the A10 miners will stop working on these coins. Anyone have knowledge about these miners?
|
|
|
Hello,
I have got 4 A10 500 MH ethminers deliverd in January 2020 When did Innosilicon decide to add the 5Gb ram to the model as the specs of the current A10 pro model are the same as my machines. The Powerdraw is 860 watts with 500 MH hashrate. The 485 MH A10 model seems to be the old model after they upgrade it to an 500 mh Anyone know where the ram on the hashboard is located on the hashboards?
Best regard,
Arthur Verboon
|
|
|
|