Hi,

I've been having problems with all 3 of my S2's - they boot up but won't connect to the network.  I think it may be the IO board (specifically the ethernet port on them) and am looking to see if anyone has one (or 3) they are will to part with. 

OR - if you live in the Charlotte, NC area and are willing to bring your S2 IO board by to verify this is the problem (will pay for gas  ) - please let me know.

It is killing me that I have 3 S2's just sitting idol here......

BTW - I've contacted Bitmain but they have not been very helpful.....

Thanks.

Hi,

I have 3 S2's and they all started having the same problem today.  I had to replace my router and when I installed the new one none of my S2's will connect.  They all boot and the LCD screen displays their internet address, but they never appear on my network.  The blue light on the controller board is on - I've had to reflash one of them before - but when that happened the S2 never even booted up all the way.

I now the cable and internet connection work because I can hook my laptop up to the same connection and can access the internet.

Any suggestions?

Thanks.

Hi,

Today I started experiencing a problem with my Terraminer IV.  When I plug the PSU's in, the CTR1 light comes on (yellow) for a few seconds and then nothing.  The fans are all running, but neither of the Miner lights light up and it never registers on my network.

I tried the reset button but that didn't help.

Any suggestions?

Thanks.

PS - I should have mentioned that I had to install a new router today.  And the problem started after that. Could there by any settings on the router that are causing isssues?

Hi,

I was wondering if anyone has both an S2 and an SP10 and can comment on the noise difference between them.  I have a Terraminer and a couple of S2's and was look at whether to get another S2 or try the SP10.  All my equipment is in my house mostly in the basement and a guest room.  Since I can close the doors the noise is muffled, but I heard the SP10 may be really loud.

Any feedback would be great.

Thanks.

Hi,

I have a Terraminer IV and have been running it for about 3 weeks.  I've noticed that after about 24 - 30 hours it drops to 50% hashing.  If I restart it (unplug both PSU's and then plug them back in) it resets and runs fine for about another 24- 30 hours.  It has been doing this consistently for about 10 days now.

Has anyone else experienced this problem?  Any ideas or suggestions?

Thanks.