Show Posts
|
Pages: [1]
|
I have been running a mining pool at home for a while now (MiningCore - LOVE it), and it's used only for home mining (only in-house mining) and I'm interested in trying another pool software. We mine for fun and we chose in-house for learning, etc. If money were no object - what would be the very best pool to install and run? I would need a fully supported pool so it stays updated as new releases come out. Regardless of all the reasons why NOT to run a pool at home, what is available to purchase? It seems that finding commercially-available pool software is very elusive and difficult to find. Current coins we mine for are BTC, BCH, ZEC, DOGE. Any suggestions?
|
|
|
Not that this is happening anywhere, but i have always been curious if a pool could change the miners BTC address when a block is found. So the reward goes somewhere other than to the miner that found it.
Mainly curious if this =could= be done and if yes, how could I spot it happening. It may be impossible but I wanted to know.
Thanks
|
|
|
I have been on a quest for the past 2 years to find some old wallets I used back in 2012 and up. I lost interest in the whole BTC stuff in 2015 and now realize my wallet(s) may have quite a bit of BTC sitting idle. Problem is i've replaced hard drives over the years and have overwritten a lot of stuff, etc. I have 26 old drives in a shoebox but there are no typical c:/User/me/AppData/Roaming/Electrum/... type of paths which would make my life easy.
Is there a string I can look for that would tell me when I've found my electrum wallet? I want to see if any of them are still viable/in-one-piece. Or any string that would put me "close" to my wallet where I can sift through the data on the drive to see if I can find it?
Thanks
|
|
|
I somehow bricked my S5 by trying to load in a fan speed control update via the traditional upgrade screen. Upon reboot the device just kicks in the fans at max speed and never boots the o/s. Is there any way to get back into the device via a SD connection or other on board connector to load back the proper boot file? I don't see any common SD slot or connector unless I am missing it. Thanks
|
|
|
|