EthDcrMiner64.exe -epool stratum+tcp://us.ubiqpool.io:8008 -ewal 0xc86bb711033e00abd01b197a57be42421678a987 -epsw x -eworker rig1 -allcoins 1 -dpool stratum+tcp://dcr.suprnova.cc:3252 -dwal neverrazor.1 -dpsw x
Your hashrate is at ~50% of your's equipment normal performance. I thought that mining intensity was set wrong (ethi and dcri). After runing a short test, I found that GTX1060 are not very sensible to dcri level (at least DCR). Cranking DCR intensity from 40 to 130, the DCR hashrate increased 190% and ETH hashrate decreased 10%. Such dcri level, to halven the ETH hashrate, should be within 200-300 range, that is either stupid or unsupported by Claymore miner.
Better define explicitly your ethi and dcri, say 16/40, 16/50.
Check your BIOS settings - enable Above 4G decoding/TOLUD (works only in UEFI-enabled systems) and PCI-E speed - switch it to Gen1 or Gen2.
i enabled 4g ... and tried different pci-e gen speed all same results ... the problem is ONLY in the hashrate of eth ... .. i tried another eth miner ... same problem
I seem to be having the same issue on my Asus Z270 board with 5 Rx 580's hashing all at around 23mg/h each, another one of my rigs with same config but older asrock H81 board and 6 rx 480 is 31mg/h each.
What version of Claymore do you use?
What AMD driver do you use?
Claymore Ver 10, Win 10 pro with latest Blockchain drivers. In fact prior to blockchain drivers I was only getting 21mg/h per card. I wonder if I'm only running 5 cards on a asus z270 if its still necessary to change bios settings on the motherboard? I'm thinking probably yes, which I did anyways. Also if I turn up settings in AB the cards go down to 18-19mg/h each
Did you use crimson 17.10.2 ?
Did you change the graphic to compute with AMD driver ?
Did you modded the bios with trap 1500 ?
Did you install ATIDAG fix?
Look for BBT videos of setting Asus z270 to see if you miss any step of bios setting
If Rx 580 hashing around 23mg/h, look like it's at original state without, It should get around 25.3 with bios modded (not using AB yet) I'm just listing some possible steps of setting for my2cent
I got rx 580 4 GB with -40 power limit and -100 mv voltage for hashing around 27.8 mg/h and I see that even power limit set, amd cards still pull more power
Thanks
Show Posts
