We are using s9, the advertised hash-rate for that batch of miner is 11.85th/s.
It looks like the reset issue in 7a is not solved.
Miner constantly restarting over and over again even after it ran through the config process. hw errors are low to non existent at all so im not really sure why the firmware is set to reboot the miner over and over again. its so bad that the pool i use shows my hashrate is only 400gh/s out of the reported 13.2th/s on the status page and thats because it spends almost as much time restarting than it does actually mining.
Using the latest v7a.
Any ideas
after i go back to the stock firmware the miner runs at 11.7xxth/s all day non stop.