TYVM.  Hard reset as instructed seemed to get things going again.  No HW errors atm and running at full hash rate.  Would I still be able to run at full hash rate if board was bad?  Is there another reason it would only periodically get these amount of errors?  Pretty frustrating no knowing 

Hi All,

Brand new to mining.  Just got 3 V9s and got them up and running Some pics of the set up:

https://i.imgur.com/2dq9w8m.png
https://i.imgur.com/tBpzu12.png
https://i.imgur.com/Er1fnUo.png
https://i.imgur.com/NQgquG5.jpg
https://i.imgur.com/aDpB7cs.png

The goal here is to eventually use a submersion system with 3M Novec or plain ol' mineral oil.  The V9s are just a test of using a setup like this.  The cooler provides incredible noise dampening as well as..ahem...cooling.  The device on the side is a thermo-switch so that the freezer only turns on when above a certain temp inside (so it's not constantly on, only keeps it below a certain temp).

Anyhow, miners ran fine at first but now it seems boards randomly turn off:

https://i.imgur.com/MLwRvxH.png

The above pic is a screenshot just taken where one board has turned off.  I have no idea why, what could have caused it or what any of the info shown related to the chain means.

Is there a key somewhere for all the abbreviations and acronyms listed in the miner's admin pages?  What about the values?  What should one be looking for when troubleshooting or verifying operations?    

Any help would be greatly appreciated.

---

Moderator's note: This post was edited by frodocooper to remove inline image tags.