Hello Guys,

Hope you are doing well. Can you please clear my doubts?

What is the recommended temperature for PCB & Chip for Antminer? Is it the same temperature for all Antminer models?

Recently, I purchased 2 units for T17+ 64TH

I use Awesomeminer for remote monitoring. Awesome miner shows me both PCB & Chip temperatures

it shows highest PCB temperature as 51C, and that miner shows Chip temperature as 78C





According to Awesomeminer, if chip temperature goes 80C or above, then it turns yellow

Does it mean that going 80C or above for chip temperature is dangerous?

Also, do you think the miner firmware is reliable? because I had experience with Antminer S9 model in the past where the hash board got fried, and the status page was showing 200C for the board
I think it was my mistake that I replaced the miner fan with another fan to lower noise level, when I woke up the next day, the fan was not spinning, but the firmware should have stopped mining once 80C was crossed right? I feel there is a delay for between temperature check, and fan RPM adjustment, and by the time firmware checks the temperature, then it is game over for the hash board before adjusting fan RPM.

Thanks @favebook & @HagssFIN

According to S19 Manual it says:

The equipment has two power inputs, only by connecting those two power supply sockets simultaneously can the
equipment run. When the equipment is powered off, be sure to power off all power inputs.

Hello,

I have doubt, and appreciate if you guys can clear it.

Nowadays, new miners come with attached PSU, and require two power cables to turn on.

Is there a specific order for turning on the power for the cables, or it doesn't matter, so just turn on the power in any order you like?

Suppose I connect the two cables to two separate electric sockets on the wall. Which one should I turn on, or it doesn't matter?

Thanks

So what is the status so far? I have been getting paid in ETH for a period from WestLandStorage address 0x4Ac6307A85D83962503f86457de9c331a6926F48

Now, you can see here https://etherscan.io/address/0x4ac6307a85d83962503f86457de9c331a6926f48

No out-coming transfers from this address. Only incoming transfers, and the address ETH balance is growing each hour.