Show Posts
Hi,
Could you help ?
I have an H-board v1.2 and rpi and M-board 2.3.
It's working but after my sd card is crashing. I make another from V1 img.
And now it's not working....
for example when i running the chainminer program:
pi@bitfury /opt/bitfury/chainminer $ sudo ./miner
INIT: 16 chips detected
^Cpi@bitfury /opt/bitfury/chainminer $
i make a new chainminer install and make, but same answer
i have no chip.conf and no best.cnf ... is it problem ?
Mboard 2.3 and newer can't use the v1 image due to the way the slots are connected and activated by chainminerCould you help ?
I have an H-board v1.2 and rpi and M-board 2.3.
It's working but after my sd card is crashing. I make another from V1 img.
And now it's not working....
for example when i running the chainminer program:
pi@bitfury /opt/bitfury/chainminer $ sudo ./miner
INIT: 16 chips detected
^Cpi@bitfury /opt/bitfury/chainminer $
i make a new chainminer install and make, but same answer
i have no chip.conf and no best.cnf ... is it problem ?
You might also tryout bfgminer
On the note of sdcard corruption. If you have a spare 8Gb+ flash drive laying around you can follow this guide
http://www.raspberrypi.org/forum/viewtopic.php?f=29&t=44177
Shows you how to move rootfs onto a USB drive that way the only time sdcard is touched is at boot. After that it's all from usb
Thanks for your quick answer....
I think i have enough space on my 4G SD Card
Filesystem Size Used Avail Use% Mounted on
rootfs 3.4G 2.0G 1.3G 61% /
/dev/root 3.4G 2.0G 1.3G 61% /
devtmpfs 235M 0 235M 0% /dev
tmpfs 49M 212K 49M 1% /run
tmpfs 5.0M 0 5.0M 0% /run/lock
tmpfs 98M 8.0K 98M 1% /run/shm
/dev/mmcblk0p1 56M 19M 38M 34% /boot
Can is ask a link for v2 img file ? If you can....
