So I just got my first antminer s1 (yay!) and have it setup and hashing away.

Not overclocked, getting right at 180GH/s.  

Checking the status page though, I'm a little perplexed - I see chain #1; but not chain #2 for the second blade .... but it has to be working right; with the hashing rate of 180?

I did a couple searches but haven't come across anything and all the other screen shots I see show both blades.

Also my Load numbers in the upper left are typically hovering between 2.00 and 2.30 ...but have seen them as high as 3... what do these specify exactly?

Just for some info:
each blade has its own power supply.  One's a ThermalTake TR2 600w.  The other is some Logisys 550 (3.3+5v+12v 400w / 12v@25A).
did a reboot.
tried different browsers.
have NOT done a reset.

Anyone have any ideas why Chain 2 isn't showing up; or if it is something to even be concerned with?

EDIT NOTES: Miner was already on the Feb 2014 Firmware :S.  Pool reports full hash rate as well.