According to the above node, whether they should eccoin.conf file modification for the following ?
listen=1
server=1
daemon=1
maxconnections=100
rpcuser=
rpcpassword=
addnode=192.99.141.216:19118
addnode=38.93.234.100:19118
.
.
.
rpcport=19119
rpcconnect=127.0.0.1
i suggest use this:
ECCoin.conf
------------
noirc=1
listen=1
server=1
daemon=1
maxconnections=30
rpcuser=yourusername
rpcpassword=yourpassword
addnode=192.99.141.216
addnode=38.93.234.100
rpcport=19119
------------
its good to start only with a few nodes where i know they are maintained and on right chain
its good avoid getting peers from irc because there all old wallets spam themself too as peer (if ecc havent disables irc per default but noirc=1 make sure its not used)
100 maxconnections is a lot if u run multipole coin wallets its better use less active connections i go with values between 20 and 40 deepending how important that coin is to me
rpcconnect=127.0.0.1
I tried the following config file:
noirc=1
listen=1
server=1
daemon=1
maxconnections=2
rpcuser=my own user
rpcpassword=my own pw
addnode=192.99.141.216:19118
addnode=38.93.234.100:19118
rpcport=19119
rpcconnect=127.0.0.1
Deleted all files in the appdata again and startet the client, now synchronizing with network only using the two nodes from config file.
Going very fast, nearly 30000 blocks downloaded at the moment, hope i can go over block 77049 this time.
Nope, stuck again at block 77049 - Restart wallet, nothing changed
My next unconfirmed transaction is my first mining transaction, is this the reason?