Show Posts
Especially love the boot speed of version 019 but...
Maxximus007 temp control is not working and I cannot adjust fan speed from command line. Get the "Error assigning value x to attribute 'GPUTargetFanSpeed'" message. lspci | grep VGA shows the 1080TI cards and I attempted to manually adjust xorg.conf so that bus ID's under Devices would match. I can manually set fans using the nvidia-settings control panel in X, but not otherwise. I tried all combinations of potentially relevant 1bash settings. Also tried on two different supported motherboards and with fresh nvOC images. Fan/temp was working fine on 018.
Maxximus007 temp control is not working and I cannot adjust fan speed from command line. Get the "Error assigning value x to attribute 'GPUTargetFanSpeed'" message. lspci | grep VGA shows the 1080TI cards and I attempted to manually adjust xorg.conf so that bus ID's under Devices would match. I can manually set fans using the nvidia-settings control panel in X, but not otherwise. I tried all combinations of potentially relevant 1bash settings. Also tried on two different supported motherboards and with fresh nvOC images. Fan/temp was working fine on 018.
Anyone else having problems with 1080 TI FE cards on 0019?
I came to notice that in xorg.conf the Devices were set to 1050 TI. Correcting those values and rebooting did not fix the fan speed issue.
I then realized that "lspci | grep VGA" shows NVIDIA cards are installed not the model.
Just "01:00.0 VGA compatible controller: NVIDIA Corporation Device 1b06 (rev a1)"
EDIT: Doing first boot with a monitor plugged in seemed to sort whatever issue I was having with v19 and fan control. Headless worked fine after that. Thanks to fullzero and others contributing to this awesome project
