Everything works so far with version 4.12.0. Except for the frequency setting, only run at 100 GHz

/usr/bin/ld: cgminer-driver-gekko.o:(.bss+0xd48): multiple definition of `modminer_drv'; cgminer-cgminer.o:(.bss+0x2078): first defined here
/usr/bin/ld: cgminer-driver-gekko.o:(.bss+0xdd0): multiple definition of `bitforce_drv'; cgminer-cgminer.o:(.bss+0x1ff0): first defined here
collect2: error: ld returned 1 exit status
make[2]: *** [Makefile:893: cgminer] Fehler 1
make[2]: Verzeichnis „/home/pi/mining/newpac/cgminer“ wird verlassen
make[1]: *** [Makefile:1837: all-recursive] ERROR 1
make[1]: Verzeichnis „/home/pi/mining/newpac/cgminer“ wird verlassen
make: *** [Makefile:796: all] ERROR 2

STILL THE SAME ERROR...

I changed it, sorry.

Hello, I have a Raspberry Zero WH with 7 port RSHTECH USB 3.0 hub.
Raspbian Pi OS Lite 32 bit. 4x GekkoScience NewPac 22 bis 45 GH/s

Everything runs normally

 sudo apt-get-Update sudo apt-get Upgrade -y sudo apt-get install -y build-essential git libusb-1.0-0-dev libusb-1.0-0 libcurl4-openssl-dev libncurses5-dev libudev-dev screenlibtool automake pkg-config libjansson-dev mkdir -p git/vthoang; cd git/vthoang Git-Klon https://github.com/vthoang/cgminer.git CD-CGminer CFLAGS="-O2" ./autogen.sh --enable-gekko

Then "make -j 2" comes with an error message. c
Collect2: error:ld gab 1 Exit [2]: 中重 ?? [Makefile:893: cgminer] Error 1 makel21: m/home/pi/mining/newpac/cgminer" make1l: [Makefile: 1837: rein-rekursiver Error 1 makel1l: /home/pi/mining/newpac/cgminer" machen: [Makefile:706: alle] Fehler 2  

And the installation stops.
Does anyone have a solution?

Hallo, ich habe einen Raspberry Zero WH mit 7 Ports RSHTECH USB 3.0 Hub. Raspbian Pi OS Lite 32 Bit. 

Alles läuft normal

CFLAGS="-O2" ./autogen.sh --enable-gekko 
Dann wird "make -j 2" mit einer Fehlermeldung geliefert. collect2: error:ld gab 1 Exit-Status zurück machen[2]: 中重 ?? [Makefile:893: cgminer] Fehler 1 makel21: m/home/pi/mining/newpac/cgminer" make1l: [Makefile: 1837: rein-rekursiver Fehler 1 makel1l: /home/pi/mining/newpac/cgminer" machen: [Makefile: 

Und die Installation stoppt. Hat jemand eine Lösung?