Show Posts
Quote
Upgraded a couple of S1s, first went smoothly, second does not work at all. Miner Status page just shows "This section contains no values yet"
Have upgraded firmware to each option available but no joy with any of them.
Blades do not get hot and the red LED on each on does not light. Sometimes the odd quick flash during power up but nothing else.
Anyone any ideas? Is there a way to work out what is going wrong?
Have upgraded firmware to each option available but no joy with any of them.
Blades do not get hot and the red LED on each on does not light. Sometimes the odd quick flash during power up but nothing else.
Anyone any ideas? Is there a way to work out what is going wrong?
Perhaps bad form to reply to my own question, but this might be useful to someone else.
Problem now solved. I took a backup from the working device, the restored it on the non working one.
Switched off the working device (because both now have the same IP address)
Logged into the newly restored miner and changed IP address
Switched on the original working device - Result - both miners now upgraded and working.
