3
|
Alternate cryptocurrencies / Mining (Altcoins) / Re: [Mining OS] SimpleMining.net - Easy to use GPU MINING Operating System
|
on: August 30, 2017, 12:37:48 PM
|
Hi everyone, i have 2 problems running this OS with nvidia GPUs (1060 6GB).
Problem 1 - no GUI I download fresh image for NV GPU, and when i start it got only text terminal. How start GUI? Running version for AMD GPUs GUI start by default.
Problem 2 - overclocking How to downclock core? While mining ETH theres no need to GPU core run on full speed. Under Windows I set core for -400MHz and hashrate are the same like on default clock. Negative value are not allowed. And second thing. Is there a way to turn of P2 State. To OC memory clock for 500MHz , from 4000 to 4500MHz, I need to set offest at 1400, so GPU definitly go in to P2 State and drop the clock.
|
|
|
10
|
Bitcoin / Hardware / Re: Bitmain's Released Antminer S9, World's First 16nm Miner Ready to Order
|
on: June 17, 2016, 02:52:53 PM
|
Ok, my S9 start working a bit better. https://s32.postimg.org/53zy2xn91/s9_625_Mhz.pngMost important thing was set fan manualy at 90%. After this at 650Mhz get 13TH+ but with quite a lot HW errors (0,0015%). After lower frequency to 625Mh HW drop to 0.0003% and speed stabilized at 13,1TH. Strange thing is that miner need few restarts to hashig properly, sometimes 1 board hang at 3TH and dont want speed up. those chips temps are wayyyy too high my friend. your running some dangerous numbers. they should never go much higher than 70 degrees c at the chip and each day it runs like that it loses a little more life until it finally dies. if posible i would try fixing this sooner rather than later. i dont want your hardware throwin out that magic smoke. No they are not. For GPU yes, but not for ASICs.
|
|
|
11
|
Bitcoin / Hardware / Re: Bitmain's Released Antminer S9, World's First 16nm Miner Ready to Order
|
on: June 17, 2016, 01:13:23 PM
|
Ok, my S9 start working a bit better. Most important thing was set fan manualy at 90%. After this at 650Mhz get 13TH+ but with quite a lot HW errors (0,0015%). After lower frequency to 625Mh HW drop to 0.0003% and speed stabilized at 13,1TH. Strange thing is that miner need few restarts to hashig properly, sometimes 1 board hang at 3TH and dont want speed up.
|
|
|
|