Avalon Voltmod?

[candoo]

Hey folks,

is there any way to give the chips more Volt? (I know there is much more needed then air cooling).

I get lots of HW errors with a frequency higher then 365 and I think they need a little bit more volts!.

The temperature of the chips is only at 45-50°C! (max is 70 in the chip spreadshet) so I could give him a bit more overclocking.

[Keninishna]

The only problem is everyone is too scared to fry their precious avalon chips.

[fasmax]

I think the real problem is the regulator chip is only rated at 20 amps.
So I don't think increasing the voltage will help much or not at all.
But to answer your question.
The resistor at R10 is a 10.5K ohm resistor if you were to replace it with a 10.0k ohm resistor you would increase the voltage a few hundredths.
I suspect Avalon has already found that the 10.5K ohm resistor is the best value to use it sets the voltage at about 1.15 volts.