Blade Rev. 2.01 not mining

[ZBC3]

My blade v 2.01 has been working fine since September. However, yesterday the chip went to xxxxxxxooooooxxxxxxxxx, and was reporting a hash rate of 24 ghz using 550 PSU. I tried resetting with  1&2, and 2&3 and now the configure page is not working. The yellow & green led's are flashing on the cat5 connector and the green led below the cat5 connector flashes when I power on the blade. Any suggestions as to why I can no longer access the configuration page?

[vm1990]

id try changing the ethernet cable if that dosnt work its more than likely a power supply problem