my avalon batch4 psu break down

[zkfq123]

the psu is 1000w
and i have  another two 600w power

how can i use these 2 psu togther?

[dogie]

the psu is 1000w
and i have  another two 600w power

how can i use these 2 psu togther?

Not sure you could balance load on an Avalon, would be very risky. Either sell the Avalon or buy a bigger PSU.

[zkfq123]

OpenWrt | OpenWrt Barrier Breaker r38031 | Load: 0.34 0.17 0.11Changes: 0

i have connect 2 pus and
 found that i can only run avalon1 as 300hz with 4 batch
or 375hz wiht 3batch

[dogie]

OpenWrt | OpenWrt Barrier Breaker r38031 | Load: 0.34 0.17 0.11Changes: 0

i have connect 2 pus and
 found that i can only run avalon1 as 300hz with 4 batch
or 375hz wiht 3batch

You're risking a fire, please buy one larger PSU as soon as you can. To anyone else, I REALLY wouldn't recommend this.

[zkfq123]

i had seen some kind of avalon2 400g use 2 1000w psu

so, i believe avalon1 can use 2 psu

[zkfq123]

i heard that  3 of pcie port in avalon need above 3* 250w power ,does anyone know that? is someone have  avalon tech book can
share to me  ?

[klondike_bar]

i had seen some kind of avalon2 400g use 2 1000w psu

so, i believe avalon1 can use 2 psu

its a relatively different system. heres what you need to check/know:

How does the power get from the PSU to the chips? If each module has individual power connectors that dont link to one another via the control board, you can use multiple PSUs to power the different modules.

But if the power DOES to the control board, THEN the modules - using 2 power supplies will eventually (probably within minutes or hours) destroy one or both supplies (possibly causing shorts and fires)

[zkfq123]

but i have connect 2 psu for avalon 3 batch at 90g@375hz for few days

one psu connect 2 batch and one psu connect the other one batch and control board

and its runs very steady.

but when i conncet the 4 batch and it down in few second even at  325hz