ASICminer Blades and HW error %

[J_Dubbs]

Does this look high or am I okay right now?

[HellDiverUK]

That's pretty good.  Mine (v1 Blades @ 13GH) do about 1-1.5% HW errors.  Most of them happen at bootup, the longer they run the less errors they make.

[J_Dubbs]

That's pretty good.  Mine (v1 Blades @ 13GH) do about 1-1.5% HW errors.  Most of them happen at bootup, the longer they run the less errors they make.

Thanks, seems I've always got one with 3%, but my average is still 1.4%.

[repairguy]

That seems a little high to me, It looks like you are not overclocking them (avg 10.9)  It should be less than 1%.  How are you cooling them?

[novymivo]

ok

[J_Dubbs]

That seems a little high to me, It looks like you are not overclocking them (avg 10.9)  It should be less than 1%.  How are you cooling them?

They are v2 blades, 9 are on a backplane in a milk-crate type open container. I have 3 sickle-flow cooler master 120mm fans on each side, all punching in the same direction. Then the blade running solo has 2 120mm fans on the heatsink, a 140 on the back, and an 80mm sucking air out the top. It's a weird rig, everything is suspended with zip ties and I used folder racks to mount it. I was considering adding an exhaust fan to the top of the backplane, but everything seems "good enough" so I didn't bother. Do you think I need more cooling? I can post pics? I am getting 104gh/s, which I believe is considered good for the v2 blades(?).

[J_Dubbs]

Added a cube on the same proxy... It seems like the errors are resolving as it goes, down to 1.9% right now, but the blades are reporting between 8-12gh/s, which I know is not true. When I go into my web UI for the blades I notice some are only at 93% efficiency, but they are hashing over 10gh/s. Does this mean I've loaded up this proxy as much as I can? I've got another cube on the way and I need to figure out where to point it...