 |
May 28, 2021, 03:26:43 PM |
|
Hey so I have a Whatsminer D1 that would fire up and recognize the 3 boards, but only show 70 chips on 2 boards and 0 chips on the third board.
I checked voltage across the 2 pole connectors from the PSU and it read 14 volts. As I was checking, the small cover with the control board slid down and contacted both pole connectors at the same time. The machine shut down or went into what I thought might be protection mode. I killed the power and waited 10 minutes, then fired it back up. An error code 210 showed up, and now there is 0 volts between the pole connectors. I disassembled and checked the PSU and can't find a fuse inside that might have blown.
Is there something I should look for, or has anyone else experienced this?
Makes me very nervous since it's impossible to find spare parts right now. Maybe someone knows where I can find parts these days?
Any help or advice would be greatly appreciated, thanks in advance.
|
