AC is dangerous for your bills
BINGO AC is for humans, GPUS operate just fine in a hot environment, so long as the cores themselves stay below 76C, but I always run below 70C, so my cards last forever. These days they cannot be replaced, so I care for them.
Like the guy here said, U can waste more money on the AC than on the GPU; U don't need to sleep with the mining rigs; If u can't handle the heat, then switch to HDD mining, if u must sleep with your miners, if your miners are in a closed room, then u don't need AC, so long as u have source of fresh air and exhaust and lots of fans in the closed space. However u must keep the closed space less than 45C as the cards run about 30C above ambient, lots of ways to 'cool' the closed space, some use heat-pumps with water running pumped into the ground & back and then put radiators in front of the fans.
I fabricate my own "Grow Tents" where I suck in clean air at the bottom of the tent, and pull out hot air on top; The tents are in my outdoor motorcycle garage, largely because the use of tents allow me to have clean air ( i run cheap purifiers ), dust is the worst enemy of gpu mining, the bunny's kill components;
Even if u have an apartment with a balcony u can run a tall grow tent that contains a full rig shelf for 3-4 rigs, as long as the tent is well constructed an out of direct sunlight you can have clean, dry air <45C at 35C ambient. When I say grow tent I don't mean to buy one, U build them with 2x2 lumber and 5mil plastic, I double up the floors & roof, never seen water get in.
Just trying to cover ways to avoid AC, and run the rigs where they don't need AC, as IMHO AC is for humans, and I hate AC; But in the hot season I run very few computers or gpus indoors to avoid creating the heat, noise isn't bad, but 2+ gpus at 100watts is a lot of heat, 12 gpus is a ton of heat.
U can buy air-purifiers and air-dryers super cheap, but most important is to monitor temp & humidity daily.
The most important thing in GPU mining is cleaning the boards, weekly inspection and then tear down and full clean and reapply thermal-grease; When u see the dust bunny's; U will know when to clean besides inspection daily monitoring of gpu temp, if u see a few boards ( usually inner on rig ) climb 1-2C that means the airflow is blocked, clean immediately.