AX1200i dies immediately after starting up - KNC Titan

[Clappy]

Hello,

I just bought an AX1200i and an AX760i to power a KNC Titan. After connecting everything up, I hit the power and both PSUs shut off almost immediately with a clicking noise. I've seen lots of similar reports, but I can't find a solution. I've got the 24pin jumped correctly, all connections are tight, and I am using the KNC supplied Y cables.

Does anyone know how to get these supplies to run with a Titan?

[philipma1957]

Hello,

I just bought an AX1200i and an AX760i to power a KNC Titan. After connecting everything up, I hit the power and both PSUs shut off almost immediately with a clicking noise. I've seen lots of similar reports, but I can't find a solution. I've got the 24pin jumped correctly, all connections are tight, and I am using the KNC supplied Y cables.

Does anyone know how to get these supplies to run with a Titan?

searing   should know

his profile

https://bitcointalk.org/index.php?action=profile;u=99165

[Clappy]

Thanks! I will message him.

[Searing]

Sent you a PM ..If I can't figure it out I will refer you to bigger guns that can do more

later

brad

[dogjunior]

Hello,

I just bought an AX1200i and an AX760i to power a KNC Titan. After connecting everything up, I hit the power and both PSUs shut off almost immediately with a clicking noise. I've seen lots of similar reports, but I can't find a solution. I've got the 24pin jumped correctly, all connections are tight, and I am using the KNC supplied Y cables.

Does anyone know how to get these supplies to run with a Titan?

I used a AX1200i once to try and power a Titan cube. Caused the same issue. The Corsair AX1200i has a power throttle on rails to protect from over current.