Bitmain V9 miner testing

[zac123]

Hello everyone.  I know not a lot people have much good to say about the V9 but I thought it was fairly cheap to buy and I have a free electric source for this rig so I figured what the heck.

I connected it up to nice hash no probs and it seems to start mining straight away but it only seems to mine for a few minutes before it flat lines for a few minutes. It reports 0 accepted speed until after say five minutes then it starts mining again.

Ok so thought I'd connect it to slushpool to test it but I can even get the miner to appear under the workers list. Left it for several hours but nothing.

What do you guys think. Anyone had similar issues?

Thanks
Zac

[fanatic26]

If you factory reset it and let it run with the default antpool info does it run?

[zac123]

If you factory reset it and let it run with the default antpool info does it run?

Yes,

I currently have it connected to antpool and as far as I can tell it's doing the same as with nicehash. But at least it's connected..... It wouldn't even display on slushpool control panel

[BitMaxz]

Try restore factory settings by holding a reset button check the guide here https://enforum.bitmain.com/bbs/topics/3957

If reset won't work try to update it with new firmware use the firmware here https://shop.bitmain.com/support.htm?pid=00720180209143442409014df2DA0612
Then do a factory reset and try to run your miner again and check if it solve the issue or not.

[zac123]

Try restore factory settings by holding a reset button check the guide here https://enforum.bitmain.com/bbs/topics/3957

If reset won't work try to update it with new firmware use the firmware here https://shop.bitmain.com/support.htm?pid=00720180209143442409014df2DA0612
Then do a factory reset and try to run your miner again and check if it solve the issue or not.

ok i will try this thank you. are the symptoms i describe normal? also should i expect it to hash @ 4TH constantly or should i expect this to fluctuate?
thanks.