s9 mining screen doesn't show anything

[Kidsid63]

I set my s9 miner up everything seems to be running fine such as no beeps or red lights. set my mining pools up still everything good but go to miner screen it doesn't show no stats, the screen comes up but it doesn't show hashrate and the pools. i did download the latest firmware from bitmain to make sure i have up to date firmware.

[favebook]

S9 does not have speaker so it cannot "beep".
No one can help you unless you post Kernel Log and screenshots of Miner Configuration and System.

Use code function please for long lines like Kernel Log.

[philipma1957]

I set my s9 miner up everything seems to be running fine such as no beeps or red lights. set my mining pools up still everything good but go to miner screen it doesn't show no stats, the screen comes up but it doesn't show hashrate and the pools. i did download the latest firmware from bitmain to make sure i have up to date firmware.

too bad you fucked up.

you now locked the miner to bitmains firmware forever.

why did you load firmware without asking if you should.

well it is cheap low cost gear so dont feel so bad.

go to system go to kernal log and put it in code

Code:

 in code format looks this way. quote me to,see what to do to code your kernal log

[mikeywith]

I set my s9 miner up everything seems to be running fine such as no beeps or red lights. set my mining pools up still everything good but go to miner screen it doesn't show no stats, the screen comes up but it doesn't show hashrate and the pools. i did download the latest firmware from bitmain to make sure i have up to date firmware.

Try using a different browser or hit Ctrl+F5, this should bring the miner status page up, go directly to this link http://192.168.x.xxx/cgi-bin/minerStatus.cgi

if that doesn't work then you need to provide more details and screenshots.

[BitMaxz]

If using incognito mode or other browser do not work you can also, try to reset the miner to the factory settings by holding IPbutton for 5 sec.
It might just need to refresh the firmware after you update it to the latest version.

You can follow the 3 guides from the link below to reset the miner.
- 3 ways to reset the miner
And check the ethernet cable and maybe it's not connected properly.

[mikeywith]

try to reset the miner to the factory settings by holding IPbutton for 5 sec.

The IP Report button used "as is" doesn't reset the miner, it simply sends a DHCPDISCOVER message to your router/switch (whichever has the DHCP  server ), sometimes the DHCP server fails to send a DHCPOFFER and the miner doesn't get an IP, but then the miner keeps waiting for the DHCP server and that can go forever, so this IP Report button sends another DISCOVER message in an attempt to get an IP address, but if you are already connected to the router and your miner has an IP address (OP said he set the pool worker and all that) means he indeed has an IP address and pressing the IP button for 5 seconds will do absolutely nothing.

With the being said, holding the IP Report button prior to powering the miner on without letting go for a few seconds after the miner has been turned on will reset the miner to it's default settings.

A side note: since APW3/APW7 don't have an on/off button this isn't exactly easy to do, you can hold the PSU still using your leg (knee/foot), use one hand to press the IP report and another hand to plug the cable in, of course if your miner is somewhere high this trick won't work.