Right sizes and model resistors and capacitors for hashboards

[moftkhor]

Hey guys,

Any fellow technicians here have an idea what range of surface mount capacitors and resistors to order for repairing hashboards?
I see a lot of different sizes. But they are too small to measure myself obviously. So it would be helpful if anyone would throw in what kit or ranges to buy so it would cover pretty much most of the S17 model hashboards.
Or just throw in a link and I'll look for it in local shops myself.

Thank you!

[BitMaxz]

Try to contact zeusbtc if they have available capacitors and resistors or try to check this link below

- https://www.zeusbtc.com/ASIC-Miner-Repair/Antminer-Parts/Capacitor/

Why don't you just check the model name of the capacitor? you can use it to search on Google to find where you can buy them. However, you can try ZeusBTC and I think they have parts that you need for s17 units.

[moftkhor]

Try to contact zeusbtc if they have available capacitors and resistors or try to check this link below

- https://www.zeusbtc.com/ASIC-Miner-Repair/Antminer-Parts/Capacitor/

Why don't you just check the model name of the capacitor? you can use it to search on Google to find where you can buy them. However, you can try ZeusBTC and I think they have parts that you need for s17 units.

I already did, they are really difficult to communicate with once you go in to detailed technical questions.
And the resistors on the board are unmarked. They are just too small...
But I found quite some info.

Apparently the resistor sizes are mostly 0201 and most resistors used are 30 ohms and I think 100 kOhms.
Still looking for the right capacitor sizes.

Zeus really isn't the most helpful. The Russian youtubers are quite good, too bad I don't really understand them... The auto caption is still far off...
But little by little I'm getting there.