question about setting difficulty for workers on BTCGUILD

[messville]

Hi Folks,

I Just had a quick question if thats OK.

I have 4 blades running on btc guild, 3 overclocked V1 blades and 1 normal V2 blade.

I have them all running on one slush stratum proxy exe but pointed at btc guild.

When I had one blade (the V2) the proxy showed 8 difficulty and I set the one worker on btc guild to the same 8 difficulty.

But now when running all 4 blades the proxy shows 32 difficulty for each of the 4 workers, not 8 difficulty for each.

My question is what do I set the worker difficulty to on btc guild for each worker, 8 or 32 ?

Any help would be greatly appreciated,

Thanks.

[1715593503]

1715593503

[1715593503]

1715593503

[eleuthria]

Hi Folks,

I Just had a quick question if thats OK.

I have 4 blades running on btc guild, 3 overclocked V1 blades and 1 normal V2 blade.

I have them all running on one slush stratum proxy exe but pointed at btc guild.

When I had one blade (the V2) the proxy showed 8 difficulty and I set the one worker on btc guild to the same 8 difficulty.

But now when running all 4 blades the proxy shows 32 difficulty for each of the 4 workers, not 8 difficulty for each.

My question is what do I set the worker difficulty to on btc guild for each worker, 8 or 32 ?

Any help would be greatly appreciated,

Thanks.

The setting on the dashboard only sets your *minimum* difficulty level, so eventually you'll always end up at 32 if you continue to use 4 blades via 1 proxy.  If you plan to always use 4 through one proxy, you should probably just set it to 32.  If you think you might change that setup later, then you might consider setting it to 8.

[messville]

Thank You for the reply eleuthria.

I will try to work out how to run multiple proxies but for now I am stuck with one so I will set the difficulty accordingly.

Thanks Again.