[FS] All aluminum open-air case frames (now with support beams for USB risers)

[Eyedol-X]

What are the sizes of these new 2 PSU versions with Riser mounts? I assume they won't stack on previous designs that were for 1 PSU?

All of the two PSU models share the same footprint and all of the one PSUs share the same footprint. 

The one PSU model will/does also have the USB support beams.  I just haven't added it to this thread just yet. 

So with the stand and 2 single PSU rigs I previously purchased, is it possible to add the 2 PSU version to stack?

Separately, can I add the riser support beams?

You can't stack one onto two PSU models, or vise versa.

A kit to add USB riser support to your existing frame is $10.

Hmm,

How about a base large enough for a 2 PSU Frame to Sit on, then some sort of Riser/Coupler to allow the smaller 1 PSU frames to sit on top of a 2 PSU base frame?

I'm thinking about building a 2 PSU frame and what to add the riser base to my 2 existing 1 psu frames but I don't want to replace my frames to do this.

Also is it possible to get additional clearance between the base of the riser supports and the mainboard? (Taller side posts) - Specifically I want enough clearance have up to a 165mm Heatsink on top of the CPU of the 2 PSU Frame.

I have some ideas on a base with outriggers similar to one I got last time but I don't know if you have bandwidth to do something one-off, let me know.

[Spotswood]

What are the sizes of these new 2 PSU versions with Riser mounts? I assume they won't stack on previous designs that were for 1 PSU?

All of the two PSU models share the same footprint and all of the one PSUs share the same footprint. 

The one PSU model will/does also have the USB support beams.  I just haven't added it to this thread just yet. 

So with the stand and 2 single PSU rigs I previously purchased, is it possible to add the 2 PSU version to stack?

Separately, can I add the riser support beams?

You can't stack one onto two PSU models, or vise versa.

A kit to add USB riser support to your existing frame is $10.

Hmm,

How about a base large enough for a 2 PSU Frame to Sit on, then some sort of Riser/Coupler to allow the smaller 1 PSU frames to sit on top of a 2 PSU base frame?

I'm thinking about building a 2 PSU frame and what to add the riser base to my 2 existing 1 psu frames but I don't want to replace my frames to do this.

Also is it possible to get additional clearance between the base of the riser supports and the mainboard? (Taller side posts) - Specifically I want enough clearance have up to a 165mm Heatsink on top of the CPU of the 2 PSU Frame.

I have some ideas on a base with outriggers similar to one I got last time but I don't know if you have bandwidth to do something one-off, let me know.

Ah, yes, all of that is doable.  Please send me a sketch.  If not too complicated, I should have the time.

[ptang]

Just wanted to add myself to the list of satisfied customers hailing from Canada that received my order today. Rack is sturdy and well built.

[flip4flop]

+1 for another satisfied customer.  I ran into some issues assembling and Rich was more than accommodating to all my ridiculous questions.

[Spotswood]

A small improvement...

The PSUs are now secured to the frame via three mounting points.

[Spotswood]

bump 

[Pistachio]

bump 

PMed.