1050Ti and 1050 mining performance

[onnaj1000]

I'm running nothing but 1070/1070ti + 1080ti cards on all my rigs, but got a bit frustrated about the rip-off charges for new cards at present, so just bought x6 1050ti cards for a new rig.

Using Simple Mining OS, mining Equihash, Core 110, Memory 800, Power 100 and getting 1020sols at 440 watts. It's not great when you looks at the sols per watt (compared to my other rigs), but the rig is earning. But these cards are cheap, so that kinda makes me feel better 

I'll see if I can tweak it a bit when I get the time.

... waits patiently for prices to come back down to earth again ...

Absolutely agree about 1050ti. My rig consists of 5x1050ti + 1070. And I am completely satisfied with the profitability of such a budget rig. Looked recently for prices in the store and was surprised that 1050ti has risen by half since last summer, when I bought my graphics card. 

Do you guys think 2x 1050 ti will be better performance and cost wise then 1x 1060 gtx 6g?

[1714936465]

1714936465

[1714936465]

1714936465

[1714936465]

1714936465

[1714936465]

1714936465

[1714936465]

1714936465

[Bigpiggy01]

I'm running nothing but 1070/1070ti + 1080ti cards on all my rigs, but got a bit frustrated about the rip-off charges for new cards at present, so just bought x6 1050ti cards for a new rig.

Using Simple Mining OS, mining Equihash, Core 110, Memory 800, Power 100 and getting 1020sols at 440 watts. It's not great when you looks at the sols per watt (compared to my other rigs), but the rig is earning. But these cards are cheap, so that kinda makes me feel better 

I'll see if I can tweak it a bit when I get the time.

... waits patiently for prices to come back down to earth again ...

Absolutely agree about 1050ti. My rig consists of 5x1050ti + 1070. And I am completely satisfied with the profitability of such a budget rig. Looked recently for prices in the store and was surprised that 1050ti has risen by half since last summer, when I bought my graphics card. 

Do you guys think 2x 1050 ti will be better performance and cost wise then 1x 1060 gtx 6g?

Slightly, but once you factor in the slot space they don't. I build 1050ti rigs using dirt cheap cpu+ram+mobo combos from net cafe repos. I like them mainly as they're mostly available and do decently.

They're not top of the line mining cards and if you're paying full price for GPU slots, they're a lot less worth it than having more power per slot. I get 3 slots for around 60$ including shitty PSUs that I tend to replace bringing my costs to around 90$ for 3 slots.

[PetrovichCoinMaster]

I'm running nothing but 1070/1070ti + 1080ti cards on all my rigs, but got a bit frustrated about the rip-off charges for new cards at present, so just bought x6 1050ti cards for a new rig.

Using Simple Mining OS, mining Equihash, Core 110, Memory 800, Power 100 and getting 1020sols at 440 watts. It's not great when you looks at the sols per watt (compared to my other rigs), but the rig is earning. But these cards are cheap, so that kinda makes me feel better  

I'll see if I can tweak it a bit when I get the time.

... waits patiently for prices to come back down to earth again ...

Absolutely agree about 1050ti. My rig consists of 5x1050ti + 1070. And I am completely satisfied with the profitability of such a budget rig. Looked recently for prices in the store and was surprised that 1050ti has risen by half since last summer, when I bought my graphics card.  

Do you guys think 2x 1050 ti will be better performance and cost wise then 1x 1060 gtx 6g?

Two cards 1050ti now cost about the same as one 1060 6Gb.
2x1050ti = 31.2 Mh/s
1060 6Gb = 25 Mh/s
Felt the difference?

[phuocduong]

i used 1050Ti, mine ETH/ETC 13 MHz, mine ZEC 85-89 sol/s

hope useful for you

[onnaj1000]

I'm running nothing but 1070/1070ti + 1080ti cards on all my rigs, but got a bit frustrated about the rip-off charges for new cards at present, so just bought x6 1050ti cards for a new rig.

Using Simple Mining OS, mining Equihash, Core 110, Memory 800, Power 100 and getting 1020sols at 440 watts. It's not great when you looks at the sols per watt (compared to my other rigs), but the rig is earning. But these cards are cheap, so that kinda makes me feel better  

I'll see if I can tweak it a bit when I get the time.

... waits patiently for prices to come back down to earth again ...

Absolutely agree about 1050ti. My rig consists of 5x1050ti + 1070. And I am completely satisfied with the profitability of such a budget rig. Looked recently for prices in the store and was surprised that 1050ti has risen by half since last summer, when I bought my graphics card.  

Do you guys think 2x 1050 ti will be better performance and cost wise then 1x 1060 gtx 6g?

Two cards 1050ti now cost about the same as one 1060 6Gb.
2x1050ti = 31.2 Mh/s
1060 6Gb = 25 Mh/s
Felt the difference?

Yes difference is quite a lot (about 25%) but what about power usage? Will 2 1050 ti will use more then 25% power then 1 1060? And what also comes in my mind now is that the 1060 6gb is more 'future' proof.

[tothanhtuan]

I got Nvidia 1060 : 6 cards. The hashrate is around 24-25 Mh/s and they cost me few dollars / hour for electricity

[agismaniax]

I have 2 x GTX 1050Ti. I'm mining ZCL.
I get total avg 388 Sol/s with power limit 90, core 205, mem 705 and custom fan control.

[akturk]

My Digital Alliance 1050ti 4G Dual OC & Galax 1050ti 4G EXOC
ETH : 15,6 - 15,8 mhs
ZEC : 180 - 190 sols

what are the settings? (galax 1050ti 4gb exoc )

[QuintLeo]

GTX 1050 right now isn't too bad on a hash/$ basis for ZEC, but they're very poor on hash/watt compared to ANY of the bigger cards - they struggle to get to 2.6 sols/watt in my experience with 2 different models of them.

GTX 1050 ti has started getting gouge priced enough I would ignore it except PERHAPS for Ethereum mining use, and even there it's marginal on hash/$ at best - and again, VERY POOR on efficiency (though closer to the big cards than on ZEC).


The odd part on these cards is that efficiency is almost completely independent of the TDP setting - VERY minor difference from the bottom-end 70% (52.5 watt) minimum setting my cards allowed to the 90% setting, and only a small change from 90 to 100.

[SpeedY_Hun]

Anyone met the same problem, when OC the ASUS 1050TI's and the hashrate decreased?
Same problem with Claymore and Phoenix.

[onnaj1000]

Anyone met the same problem, when OC the ASUS 1050TI's and the hashrate decreased?
Same problem with Claymore and Phoenix.

You should oc the memory and reduce the GPU clock and voltage. Check a few posts above this one

[SpeedY_Hun]

I tried that too, but with the same results

[QuintLeo]

The 1050 ti doesn't want core overclocked at all on ETH - there are very few IF ANY cards that are not RAM limited on ETH mining (even my R9 290 cards with the VERY WIDE memory bus are RAM limited).
It also seems limited on how far you can OC the RAM before you bump up to a higher-latency "strap" that ends up slowing ETH mining performance or it gets unstable.

There just isn't a lot of tuning you CAN do on these cards.

[Bigpiggy01]

I've found some absurd differences from card to card. But my hands down winner has to be the Galax EOC 1050 ti. Sure it requires a power connector but it's performance is great for the card class:

Dual Eth Dcr 15.2 Mh/s Eth and 608Mh/s  Dcr on Excavator

Neoscrypt 500Kh/s with the above running hsr

Equihash 192 Sol/s Excavator

Cryptonight V7 350 H/s with XMR Rig Nvida.

That's @ 75% power draw with +150 core and +800 mem that has the cards running rock solid @ 65 C which is decent given the ambient temps here.

I could probably squeeze significantly more out of them with better miners but get really varied results and funky running and these rigs are managed by the Mrs during the week so SIMPLE is the key.

[Jr.Sasha0209]

do not understand the people who buy these cards, only the place is occupied in the apartment, and when you download the broadcast by 2000 you throw them into the trash, since the complexity will fly to the nebis and nobody needs a hundred years on the market

[NiklasFalk]

Got a good deal on a pair of 1050 some time ago (two for somewhere between the price of a 1050ti and a 1060 3Gb), and they have been chugging away like champs since.
323 Sol/s at 50W each (so 3.23 Sol/W roughly at +190 core +1300 mem). No Eth of course (2GB) but they are decent at XMR (650 h/s).
ROI at current pace is about 220 days (I use the heat so I don't count the power).

[svedr]

Hi!
Yesterday I run my second, this with 8x ASUS GTX1050ti Phoenix (HYNIX) , ( my first rig have 9x amd rx580 )

I was expecting 15Mh/s ETH,
stock 12.3Mh/s,
MemClock +250 get 13,25Mh/s

I read here that you are using MemClock +700, + 900....
I can only raise it MemClock to +250, that is 3753Mhz.. If i set to +800, memclock is still 3753 in msi afterburner,
and get warrning in windows 10
 - Application has been blocked from accesing Graphic hardware....


How can I solve the problem ?
How much hash can I expect with this card and hynix memory ?

Thankyou for help!

My configuration
- GIGABYTE GA-B250-FinTech MINING
-celeron g3930
-4Gram ( 40G virtual )
-SSD120Gb
-8x Asus GTX 1050Ti Phoenix
-Windows 10
-Claymore dual ( SOLO MINING ETH)

[Viecoin]

I managed 173 sols on Equihash, 13 mh/s on ETH, and 14 mh/s on Lyra2rev2 with MSI Aero ITX 1050 TI 4G OC. I saw some Youtube benchmarks showing the non-TI being at least ~15% slower.

[Loto]

Hi!
Yesterday I run my second, this with 8x ASUS GTX1050ti Phoenix (HYNIX) , ( my first rig have 9x amd rx580 )

I was expecting 15Mh/s ETH,
stock 12.3Mh/s,
MemClock +250 get 13,25Mh/s

I read here that you are using MemClock +700, + 900....
I can only raise it MemClock to +250, that is 3753Mhz.. If i set to +800, memclock is still 3753 in msi afterburner,
and get warrning in windows 10
 - Application has been blocked from accesing Graphic hardware....


How can I solve the problem ?
How much hash can I expect with this card and hynix memory ?

Thankyou for help!

My configuration
- GIGABYTE GA-B250-FinTech MINING
-celeron g3930
-4Gram ( 40G virtual )
-SSD120Gb
-8x Asus GTX 1050Ti Phoenix
-Windows 10
-Claymore dual ( SOLO MINING ETH)

The same thing happened to me with this video card model poor overclock and low hashrate. solution was to sell it and buy a zotac msi now 15 mh/s to 15.3

[SpeedY_Hun]

Hi!
Yesterday I run my second, this with 8x ASUS GTX1050ti Phoenix (HYNIX) , ( my first rig have 9x amd rx580 )

I was expecting 15Mh/s ETH,
stock 12.3Mh/s,
MemClock +250 get 13,25Mh/s

I read here that you are using MemClock +700, + 900....
I can only raise it MemClock to +250, that is 3753Mhz.. If i set to +800, memclock is still 3753 in msi afterburner,
and get warrning in windows 10
 - Application has been blocked from accesing Graphic hardware....


How can I solve the problem ?
How much hash can I expect with this card and hynix memory ?

Thankyou for help!

My configuration
- GIGABYTE GA-B250-FinTech MINING
-celeron g3930
-4Gram ( 40G virtual )
-SSD120Gb
-8x Asus GTX 1050Ti Phoenix
-Windows 10
-Claymore dual ( SOLO MINING ETH)

My 2 Phoenix edition cards around 13,51Mh/s with +295 MemClock.