 |
November 25, 2013, 01:08:22 PM
Last edit: November 25, 2013, 03:28:31 PM by Miner3796 |
|
I would like some assistance setting up my erupter blades. Currently i have a blade connected directly to the computers RJ-45 port. Tried the default ip address for the blade with no luck. Have performed a factory reset on the blade to ensure that the ip is the default ip. Currently the RJ-45 connector on the blade has solid yellow light and blinking green light, but when opening lan connection status there are no packets being sent from blade to the computer. Have switched cables to ensure they work.
Computer settings:
TCI/IP
IP Address: 192.168.1.160
Subnet Mask: 255.255.255.0
Default gateway: 192.168.1.1
As I said the blade is connected directly to the computer. Every so often the computer notifies me a network cable is unplugged, then a network connection has been made.
The computer is also connected to wireless internet via the wireless adapter, Do I have to turn this off in order to config the blade? I wouldn't think so, but stranger things have happened.
Any help that can be offered is appreciated.
|
