MultiMiner not utlizing Block Erupter

[ford0415]

BFGMiner picks up and uses my block erupters, however, MultiMiner sees them, and uses one of them. My erupters are connected straight into my motherboard into my USB3 ports. Any suggestions?

[1713603380]

1713603380

[1713603380]

1713603380

[1713603380]

1713603380

[nwoolls]

BFGMiner picks up and uses my block erupters, however, MultiMiner sees them, and uses one of them. My erupters are connected straight into my motherboard into my USB3 ports. Any suggestions?

You have one of two options:

• Either upgrade to MultiMiner 2.0 and bfgminer 3.7
• Or specify an intensity under the SHA-2 arguments in the Settings dialog (such as -I 9)

This was a bug in bfgminer (and cgminer) that caused dynamic GPU intensity to disable ASIC threads.

[PatronDragon]

BFGMiner picks up and uses my block erupters, however, MultiMiner sees them, and uses one of them. My erupters are connected straight into my motherboard into my USB3 ports. Any suggestions?

You have one of two options:

• Either upgrade to MultiMiner 2.0 and bfgminer 3.7
• Or specify an intensity under the SHA-2 arguments in the Settings dialog (such as -I 9)

This was a bug in bfgminer (and cgminer) that caused dynamic GPU intensity to disable ASIC threads.

And why the multiminer doesn't see my Silicon Labs CP210x USB to UART Bridge?

[nwoolls]

BFGMiner picks up and uses my block erupters, however, MultiMiner sees them, and uses one of them. My erupters are connected straight into my motherboard into my USB3 ports. Any suggestions?

You have one of two options:

• Either upgrade to MultiMiner 2.0 and bfgminer 3.7
• Or specify an intensity under the SHA-2 arguments in the Settings dialog (such as -I 9)

This was a bug in bfgminer (and cgminer) that caused dynamic GPU intensity to disable ASIC threads.

And why the multiminer doesn't see my Silicon Labs CP210x USB to UART Bridge?

Make sure you have the correct drivers installed:

https://github.com/nwoolls/MultiMiner/wiki/Drivers#drivers

[PatronDragon]

BFGMiner picks up and uses my block erupters, however, MultiMiner sees them, and uses one of them. My erupters are connected straight into my motherboard into my USB3 ports. Any suggestions?

You have one of two options:

• Either upgrade to MultiMiner 2.0 and bfgminer 3.7
• Or specify an intensity under the SHA-2 arguments in the Settings dialog (such as -I 9)

This was a bug in bfgminer (and cgminer) that caused dynamic GPU intensity to disable ASIC threads.

And why the multiminer doesn't see my Silicon Labs CP210x USB to UART Bridge?

Make sure you have the correct drivers installed:

https://github.com/nwoolls/MultiMiner/wiki/Drivers#drivers

I installed this driver but multiminer dont see new! What Me Do?