Using Stratum Proxy, Constantly 'Asks for more work; !?

[Tomtheman2]

Hi,

I have my ASICMiner blade set up and running on Slush's pool. Working all fine and everything but I have noticed it 'Asks for more work' a lot more than it does actually submitting work.

What gives?

Also, for the first 2 hours, my blade was running at around 10gh/s, now its at 7hg/s ish. Changing the clock to High doesn't change anything also.

Can someone help me out?

By the way i'm on a Mac so not running any software.

Cheers!

[1715651569]

1715651569

[1715651569]

1715651569

[1715651569]

1715651569

[HellDiverUK]

Tried a different pool for an hour?  See if it's your setup, or slush's pool that's at fault?

[Ridicuss]

Hi,

I have my ASICMiner blade set up and running on Slush's pool. Working all fine and everything but I have noticed it 'Asks for more work' a lot more than it does actually submitting work.

What gives?

Also, for the first 2 hours, my blade was running at around 10gh/s, now its at 7hg/s ish. Changing the clock to High doesn't change anything also.

Can someone help me out?

By the way i'm on a Mac so not running any software.

Cheers!

When you say your blade was running 10GH/s and now 7GH/s, is that the config page reported hashrate or the rate reported from Slush?
After you select high clock do you reboot the blade?

[Tomtheman2]

Cheers for the reply. Did exactly that, switched to another pool now switched back and now it's fine.

Hashrate seems to be normal now.

Cheers for the help guys.