hello

today i install my apollo full node and a standard apollo


On first launch everything worked fine and I can log into the dashboard...then I updated the dashboard to 0.3.4

then i clicked through the dashboard and saw that the node was not started. I tried to start it and waited 5-15 minutes.. nothing happened..

then i wanted to check the m.2 card and shut down the apollo in the dashboard.. m.2 was ok...so everything was switched on again...since then it can no longer be found in the network...red led lights up and fan is off


I then connected an HDMI monitor and a mouse but the monitor gets no signal

is there a power button somewhere?

what are those mini buttons on the board?

thanks for any help