antminer L3 issues - HELP!

[daworm06]

I have four antMiner L3+. I use Blissz firmware. Never any problems until now....All four are mining away on Nicehash but the GUI doesn't show any activity whatsoever.  What the hell is going on? Not sure how to post a screen shot but there isn't anything there anyway. It's like the miner hasn't even started. I think it's weird that all four are doing it. I'm mining on NH and I tried another pool just to check...same thing. Help!

https://postimg.cc/r0N8BSn4

[BitMaxz]

This is a Bitcoin mining support board and you are asking about LTC or doge miner.
You must move this thread to altcoin mining section

Anyway, about your case, have you tried to access it with a different device and browser?
If not, try it first. If it doesn't work, then try to reset the unit to factory default and reflash the unit with firmware.

If it still doesn't work try to clean the ethernet terminal with isopropyl alcohol and test it again.

If any of these doesn't work then remove all hashboard first and test them with your extra miner by swapping the control board.

[daworm06]

Sorry, your right. + I can access it from my iphone just fine. Thanks.

[mikeywith]

I have four antMiner L3+. I use Blissz firmware. Never any problems until now....All four are mining away on Nicehash but the GUI doesn't show any activity whatsoever.  What the hell is going on? Not sure how to post a screen shot but there isn't anything there anyway. It's like the miner hasn't even started. I think it's weird that all four are doing it. I'm mining on NH and I tried another pool just to check...same thing. Help!

Are you using the lowest voltage option on the config page? if so, try switching to a slightly higher one and that should solve your issue, if that turns out to be the case you will have two options

1- keep the slightly higher voltage
2- find a newer release of Blissz (which isn't going to be easy knowing that Blissz stopped maintaining his firmware due to GPL3)

If the above doesn't work, it's your browser. Use a different browser or clean the cache on the current one, and that should fix it.

[notasimp]

Anything useful in the kernel log?