Need help with an lketc 1.5Th Dragon Miner

[FamedJester1374]

Hi everyone, I just bought a 1.5th dragon miner off of ebay. I have everything set up and running thanks to the enhanced firmware I found on this forum. My issues are what does the yellow light on top of the miner mean, and in the web ui it shows it is mining at 1.3th but on slush pool it is ranges from 250th to 550th. Does anyone have any insight, and should I disassemble and clean the dust build up from the unit. Any help would be greatly appreciated. 

[1713970368]

1713970368

[Dragonizer]

Does it have 5 boards, what do the show in'real time monitoring, thet should be 240--260Gh each.  (prob 250Gh)

Also set your difficulty to 256 on miner and Slush pool to auto detect.

[FamedJester1374]

It has 6 boards, real time shows, board 0 at 554,570.77 mh/s board 1 at 311,640.89 mh/s board 2 at 313,437.49 mh/s board 3 at 340,315.69 mh/s board 4 at 282,250.60 mh/s board 5 at 310,516.55 mh/s , for a total of 2,112,731.99 mh/s. Which should be 2.1 th/s correct? Currently slush pool shows 265.2 gh/s with both miner and pool difficulty at 256.

[Dragonizer]

Sounds like a dodgy PSU, disconnect ALL boards, and try each one in turn to see if you get 250Gh on miner and about 250Gh on Slush.

Also when in Real Time monitoring check temps, think there is a status tab or similar in top left tab.

How many fans does it have, they should be around 2.6A/4500RPM at least.

I have spare working boards/fans available if needed. But disconnect and check each one in turn...Even perfect 1Th miners that i prefer (regularly cleaned) ONLY use compressed air !!

Drag