|
Title: {FIXED} How to fix ATI Sapphire 5830 fan (dead)? Post by: mufa23 on May 02, 2013, 04:18:57 AM Was looking at one of my rigs, and the card was running at 94'C. Saw the fan kept stopping and starting, maybe 10rpm or so? His the PSU switch, and pulled out the card. I can tell it's worn down or something. The past few months it was getting louder, so I figured it was on it's way out. I can spin the fan with my fingers, but it feels like it's un-lubed or something. It doesn't spin as freely as the other fans do.
I remember seeing a thread awhile back about fixing GPU fans. Can't I drill into the fan someplace, and add a drop of a certain oil? Title: Re: How to fix ATI Sapphire 5830 fan (dead)? Post by: goxed on May 02, 2013, 05:22:00 AM Was looking at one of my rigs, and the card was running at 94'C. Saw the fan kept stopping and starting, maybe 10rpm or so? His the PSU switch, and pulled out the card. I can tell it's worn down or something. The past few months it was getting louder, so I figured it was on it's way out. I can spin the fan with my fingers, but it feels like it's un-lubed or something. It doesn't spin as freely as the other fans do. I remember seeing a thread awhile back about fixing GPU fans. Can't I drill into the fan someplace, and add a drop of a certain oil? Pull fan out with a Vice grip Apply IPA on the fan hole, put the fan in gently, rotate to clean the hole Pull fan out again Apply 4 -5 drops of engine oil or automatic transmission fluid in the fan axis hole and press fan in. Title: Re: How to fix ATI Sapphire 5830 fan (dead)? Post by: mufa23 on May 02, 2013, 06:08:23 AM Just fixed it before I read this. Thanks anyway.
I stuck two screw drivers to pop off the fan from the motor. Cleaned it out with some Hoppe's 9 then used a bit of Rem Oil. Worked like a charm! :) Title: Re: How to fix ATI Sapphire 5830 fan (dead)? Post by: chungenhung on May 02, 2013, 04:58:03 PM Just fixed it before I read this. Thanks anyway. I did that a few times, and one time broke off the fan shaft.I stuck two screw drivers to pop off the fan from the motor. Cleaned it out with some Hoppe's 9 then used a bit of Rem Oil. Worked like a charm! :) Title: Re: {FIXED} How to fix ATI Sapphire 5830 fan (dead)? Post by: greaterninja on May 03, 2013, 10:58:44 PM i tried pulling fan off with 2 screw drivers on a 5850...the freaking fan and board snapped from each other. On the good side it cost $15 on ebay to replace it.
|