Title: Built new rig GPu's not overclocking or using full performance. Post by: MylesRow on March 13, 2018, 12:34:47 PM Hi everyone.
Apologies for the limited knowledge if I say anything that sounds stupid. So within the last week a friend of mine has invested in 2 rigs and has paid someone to build them for her. Each rig has 6 1080ti's that are overclocked and running at 1800MHz according to msi according to MSI after burner. The problem is on task manager every gpu comes up as being used at 0% apart from GPU 0 which uses anyway between 1-7% So from 6 1080ti's overclocked the daily estimated sits at around 12USD which quite frankly doesnt seem correct, I can post pictures and try to reply to every message to help fix this problem as fast as possible, thank you Title: Re: Built new rig GPu's not overclocking or using full performance. Post by: theodrim on March 13, 2018, 01:00:28 PM The problem is on task manager every gpu comes up as being used at 0% apart from GPU 0 which uses anyway between 1-7% Unless you looking at compute load (in task manager) you won't see anything when mining.Which algo/miner software are you using? Did you check usage in other utilities (gpuz, hwinfo, even afterburner)? So from 6 1080ti's overclocked the daily estimated sits at around 12USD which quite frankly doesnt seem correct Again, without info on what coin you are mining no estimate can be drawn.Title: Re: Built new rig GPu's not overclocking or using full performance. Post by: MylesRow on March 13, 2018, 01:04:05 PM Oh sorry forgot to mention, equihash and as we speak its sitting at 3.4 KH/s
Title: Re: Built new rig GPu's not overclocking or using full performance. Post by: Alibatant on March 13, 2018, 01:29:37 PM Oh sorry forgot to mention, equihash and as we speak its sitting at 3.4 KH/s So that is about 560H/s each. It is slow. If you use 100% TDP, should be 750 or over. Title: Re: Built new rig GPu's not overclocking or using full performance. Post by: MylesRow on March 13, 2018, 01:36:32 PM How do I increase each card to TDP 100%
Title: Re: Built new rig GPu's not overclocking or using full performance. Post by: crypticj on March 13, 2018, 02:14:17 PM How do I increase each card to TDP 100% every card by default is at 100% TDP you need msi afterburner or similar utility to fine tune your TDP/overclock etc. |