|
Title: antminer problems Post by: Solaris1977BE on March 20, 2014, 05:00:17 PM i cannot connect to my antminer screen anymore when i type the ip in the browser,if i remember correctly i delete the wan connection (cause i could not get my miner to mine and LAN didnt seem to work-using internet cable)
Now the leds on the internetport of the ants dont light up anymore while cable is plugged in. any ideas ?(factory reset button didnt help me,or i did that wrong too) Title: Re: antminer problems Post by: the-skeptic on March 20, 2014, 08:50:41 PM i cannot connect to my antminer screen anymore when i type the ip in the browser,if i remember correctly i delete the wan connection (cause i could not get my miner to mine and LAN didnt seem to work-using internet cable) Now the leds on the internetport of the ants dont light up anymore while cable is plugged in. any ideas ?(factory reset button didnt help me,or i did that wrong too) Factory reset should be held down for 5-10 seconds after the miner boots (about 90 seconds after power-up). You might see a light show, or you might not, when you reset it. Cycle the power and it should reset to the factory 192.168.1.99. I have my miners set to static ip addresses which are set outside of the router's DHCP range, so there are no issues like this. Title: Re: antminer problems Post by: tzortz on March 21, 2014, 02:10:03 PM i cannot connect to my antminer screen anymore when i type the ip in the browser,if i remember correctly i delete the wan connection (cause i could not get my miner to mine and LAN didnt seem to work-using internet cable) Now the leds on the internetport of the ants dont light up anymore while cable is plugged in. any ideas ?(factory reset button didnt help me,or i did that wrong too) As mentioned previously , keep reset for longer time. Otherwise try to locate your S1 ip through your router addressing. . |