antminer problems

[Solaris1977BE]

i  cannot connect to my antminer screen anymore when i type the ip in the browser,if i remember correctly i delete the wan connection (cause i could not get my miner to mine and LAN didnt seem to work-using internet cable)

Now the leds on the internetport of the ants dont light up anymore while cable is plugged in.

any ideas ?(factory reset button didnt help me,or i did that wrong too)

[the-skeptic]

i  cannot connect to my antminer screen anymore when i type the ip in the browser,if i remember correctly i delete the wan connection (cause i could not get my miner to mine and LAN didnt seem to work-using internet cable)

Now the leds on the internetport of the ants dont light up anymore while cable is plugged in.

any ideas ?(factory reset button didnt help me,or i did that wrong too)

Factory reset should be held down for 5-10 seconds after the miner boots (about 90 seconds after power-up). You might see a light show, or you might not, when you reset it. Cycle the power and it should reset to the factory 192.168.1.99.

I have my miners set to static ip addresses which are set outside of the router's DHCP range, so there are no issues like this.

[tzortz]

i  cannot connect to my antminer screen anymore when i type the ip in the browser,if i remember correctly i delete the wan connection (cause i could not get my miner to mine and LAN didnt seem to work-using internet cable)

Now the leds on the internetport of the ants dont light up anymore while cable is plugged in.

any ideas ?(factory reset button didnt help me,or i did that wrong too)

As mentioned previously , keep reset for longer time.

Otherwise try to locate your S1 ip through your router addressing.




.