So I'm currently running 1 of 3 1070ti's while I wait on my larger PSU to come in to run them all. I have a Gigabyte 270P-D3 mobo.

Mining ZEN I'm currently at 457 Sol/s on this one card. I know they can reach the 500 mark however no matter what I set the OC to it does not change. Have it set to 0/0 at the moment and it is doing the same rate as when it was 200/700. Power is set to 110 watts and fan is 50% running around 65c.

It shows that the program is supposedly setting the OC settings but I'm unsure if the changes are actually happening as it does not seem to affect anything.

Any input as to what may be up with this?

I can't seem to get over 460-470 sols on my 1070ti. Currently only running one of my 3 while I wait for my bigger PSU to get in to power them. I'm using the dstm-v0.5.6 on SMOS. Tried most of the settings I've seen here plus and minus most of them. Everything sticks around the 465 range. Any suggestions?


EDIT: Mining ZEN on suprnova pool.

I actually have 3 1070ti's. Just waiting on my 1000w PSU to come in. So I'm just running this one with a 500w I had laying around to get it up and going.

And yea, that $2 isn't a problem, I made a good bit off a $20 investment last week trading so I just put enough in for a few months.

Currently trying to get SMOS up and going. I have gone through everything I've seen that was needed to go through from everything I've read and watched.

Currently have 1 GTX 1070ti installed on a Gigabyte 270P-D3 mother board.

This is the screen after starting up. Call me dumb if I'm wrong but it is not mining at this point correct?


Any help will be much appreciated!

EDIT: Well I guess it may be mining as I'm seeing profits show up in the suprnova pool. Every video I've seen was just showing differently on the rig monitor. Is that just a different setting they had ?

Also cannot find the file to make the wallet work....most likely going to just sell if this does not work...