so simply inserting a new bootable Micro SD would do the trick?

is there a size limitation on the Micro SD card? it came with 2GB

All I did was reboot
Its a sad day when  your miner is working at 1+ TH/s and then you reboot it, and its dead

also is there a size limit on the SD card i can use in this S2? it came with a 2GB micro SD card, but am thinking to take that out and not mess with it, and buy a new one to test with, but do i need a 2GB or does that not matter?

Also does it run the OS off the Micro SD card or the Pi itself? and the card is merely for memory storage and setttings?

does the OS run off the SD card? I a not familiar with the Raspberry Pi?

or does it just flash it to the Pi unit?

The reset button does nothing if you have a blank blue led screen and a red light on front panel.

how do you install the firmware if you cant connect to the miner?

you can buy my difuntional one.

Mine was up and running, but i rebooted the S2 to see if it would accept some changes and now i have a blank blue led screen with a red light in the top right corner...it was wrorking fine a few hours ago.

why cant it get pat the POST bootup all of a sudden?

where did this come from?
and how do you install it if you cant access the miner?

any luck with uploading that image?

thanks, and how do i get it on the system if i cant access it at alll....remove the sd card? and copy onto it?

can someone upload a working backup so i can reflash?

does anyone have any idea why it wont start up again after a reboot?

how come after i rebooted i get nothing on screen but the red light?

so after i rebooted the S2 I get nothing on my display and no connectivity at all..any ideas?


it was working fine from the start.

please help meeeeeee!

I guess I got lucky, I opened it up to check out the boards and they were all intact and everything in place.

I used a US plug instead of the UK plug it shipped with, turned it on, and it beeped for a minute red light came on, fans spun up fast, then went to a green light and started hashing away.

Changed the IP address and pool info, but still having trouble with the password change.

guess ill wait until he releases the manual tomorrow.

I really feel bad for the people having trouble with this...its a true crime and shame.

Where are most of the people located who had their shipments come all banged up and damaged, just curious what part of the country or world you're in.

Some of the drivers don't care about whats in the box they are dropping at your doorstep, let alone what happens to it along the way.

I hope you get it all sorted out.

Good Luck!

i keep getting "invalid password" wen trying to change the default one.

Does anyone know why or if there are certain requirements for the password?

Did anyone else have this issue in the USA? ok to use standard PSU plug?

thanks!

what did you guys do who received the wrong plug? just use a different standard one in its place?

The one I got is for the UK i think and I a in the US.

thanks!

Are there any special setup instructions needed?
Or is it simply plug it in and go to IP and configure like the S1?

Thanks!