Hi all,
I have done quite a lot of research but haven't found a resolution to this problem - hopefully someone can help me on this.
Mining rig:
3 x MSI RX 580 8 GB cards (not Armor/Sapphire etc) - has single 8 pin power connector, single fan, no BIOS switch
Windows 10
SSD with 4 GB RAM
Installed Claymore version 10 Dual miner - Ethereum mining running well and stable but issue is that I cannot get Decred to authorize
Getting:
Socket was closed remotely (by pool)
DCR: Job timeout, disconnect, retry in 20 sec...
Start.bat command:
EthDcrMiner64.exe -epool us1.ethermine.org:4444 -ewal 0x31be6e3~~~~~~~~~~~~~~~~~98c6.miner2 -dpool dcr.suprnova.cc:3252 -dwal myloginname.miner1 -dpsw 2222 -allpools 1
Troubleshooting:
- I have changed the password for the worker to match Claymore (x, 2222, other) - unable to leave the password blank for the worker
- verified Suprnova login (though there is an "x" in the active column?)
- attempted both weblogin name as well as email address used for profile
- added port 3252 in Windows firewall for both incoming and outgoing connections
- added miner to router's DMZ
- tried with/without stratum+tcp
- attempted -dpool dcr.suprnova.cc:3252 -dwal suprnova.1 -dpsw x -allpools 1 as detailed on suprnova's website
- though I can't recall which other decred pools I used but all got the same error
Any assistance or suggestions would be greatly appreciated!!
Try to change "
miner1" to your "worker name" and write "-dpsw x" command too.
Appreciations here (ETH)
0x57137Aecf8d11b60522d53eD2b0Baf0215FD0b61Suprnova already has "miner1" as a worker name - and have tried -dpsw x and with specific password as well - no change
The only real difference I can see when comparing it to my bat file is that I have -epsw x before -dpool. Not sure if it matters since that is for the Ethereum part, but may be worth a try adding it.
Show Posts
