What color are the lights on the AUC converter that's hooked up to your Pi?
Are the lights on the back of the miner, where you plug in the PCI-e boards, on?
okay looks like some thing is broken
wait wait wait check this thread
https://bitcointalk.org/index.php?topic=2215578.0if you do not have this problem above check info below
you can get to the rasp pi and program it so the eth cable looks good.
next usb micro cable to the auc conveter ---------
auc converter ---------------------------------------
four pin wire to unit --------------------------------
if any are bad you would get the symtoms you are getting.
so do you have multiple units and parts?
do you have a working unit?
if yes fully swap
the usb
the auc
the four pin wire
if dead unit works you know that one of those 3 parts are bad.
if good unit works you know that all of the part are good since each set works on good unit.
next swap psu from good unit to bad unit.
if bad unit works you know it is a psu issue.
if good unit works if means the psu is good.
at this point it would be an internal issue in the gear.
a hash board or the internal daughter board
the gear does not work if you have one bad hash board.
I did a rma check here
https://bitcointalk.org/index.php?topic=2196951.0I am hoping it is fixable without an rma
I have 64 miners I;ve swapped at least 5 of them so I know the miners are alright I only have on power supply that can handle these at the moment that could be it idk I'm using a 1300w evga PSU to try and test out a miner before I setup my building the lights on each hash board are green meaning they are getting correct power and the light on the back of the miner is yellow meaning its IDLE I've tried everything and swapped the usb cables, auc3 cables, and the auc3 to usb converters at least 3 times I have no idea what the issue is.
Show Posts
