Show Posts
Hi there I started using Claymore's v10.1 yesterday,since then my hash rate has remained the same
but stale shares have trippled.I started with the same settings I used with v10.0 and have tried tweaking
GPU settings and the like but my stale shares are still tripple that of v10.0. Has anyone else come across this issue?
Should/Can I just use v10.0 instead?
but stale shares have trippled.I started with the same settings I used with v10.0 and have tried tweaking
GPU settings and the like but my stale shares are still tripple that of v10.0. Has anyone else come across this issue?
Should/Can I just use v10.0 instead?
I've noticed the same problem on Clay 10.1, even more than 20% of stale shares with Ethermine eu1.
Rebooting everyday...
I've seen the same, switched to eu2.ethermine.org, and has been fine for last 3 weeks, been getting between 2-5% stale.
Then suddenly it shot up to 15-20% Stale, so switched to us1.ethermine.org, seems to be stable for last 48 hours, back to 3% stale.
Thanks for the help,I'll give it a try asap and post the result soon good or bad.
I had no luck switching pools so I have just switched back to v10.0,I'll let it run a few hours hopefully
its the answer.
I take my last comment back, didn't last long. WTF is going on with ethermine lately?
Has anyone experienced issues with other pools?
I'm on us1.ethermine and i'm getting constant 3-4% stale shares.
Did you already checked your card's OC? How's your incorrect shares looking?
Switching back to v10.0 has resolved my issues,I suggest you give it a try
if you haven't already its been 30hrs since I did.Stale shares are at an acceptable rate
again.My OC has not changed I did a full windows reset when i started having issues
v10.1 was clearly my issue. I'm going to get do some more homework on v10.1 and
see if its something I'm doing wrong.
I'm running 2x rog strix 1050 ti (OC core 1404mhz/mem 4484mhz) on am3 platform
with fx-8350 @31Mh/s and 2-3% stale shares ETH mode only.
