Latest posts of: ttlargura1

I was able to get mine working by burning this firmware on a new USB stick:

https://drive.google.com/open?id=1z564S10Q3SWN8-8_HmreuUCQEI_gXYl9

Not sure how to load this onto the USB, do you need to extract the files first.

Z1 not booting at all.

There is included usb imaging software in the first folder I believe. You also need to unzip the .7z file, because it contains the image. Run the imaging software and choose the image that was unzipped.

I used a different usb drive thanwhat came with it and after a couple user error problems, I got it to work.

Can you elaborate on how you got it to work? I bought a 16 GB flash drive and loaded the image via the included exe, but I can't connect to the machine's web interface to make changes or set the static ip.

Are you on a 192.168.1.x network, the default IP is 192.168.1.100

No, I'm on 192.168.0.x

That's your problem. Either give yourself a 192.168.1.x address and connect to the ASIC directly to change the Z1 IP to 192.168.0.x, or change your network to 192.168.1.x. You could cheat by changing the subnet on the network from 255.255.255.0 to 255.255.0.0

So I switched my network to 192.168.1.x, but I still can't get it at 192.168.1.100 and I can't see it on the ip scanner or my router. My service goes from cable modem to Tenda wireless router to a switch (via ethernet) and then to the asic. Any other suggestions? I've also been trying to reset it, is there a special sequence for that? Thanks for your help BTW, this one is stumping me!

It might not work now since you messed with the USB. Did the USB creation involve running an EXE program that writes an ISO image file to the USB?

I used the imageUSB exe that was included in the zip file and I wrote the z1_static_100_09_14 image file to it.

Why would you do that? You can just enter the interface and upload the new firmware from the settings. Did it work after all? I did firmware upgrade thru the interface settings and it's working for 5 days without any problems. Less Hw errors and rejects...

The ASIC was on a different network, he assumed that it was not working

I got it!

My stupid free windows unzip "App" didn't create a proper image file... re-extracted (while watching ads, not minimized) and it works! Thanks for the help!

Hello,
I think i am experiencing the same issue that you had. My miner has a red light on it and I can no longer find my IP address. It worked fine for weeks but then i unplugged it and plugged it back in and the red light was there. What exactly did you put on the USB to make it work. I tried using a new USB that i bought and putting the new firmware on it and putting it in the miner but I still wasn't able to log into my miner. Any help with this issue would be greatly appreciated.