Hello, noob here just pointed a T9 to ckpool yesterday morning. I have a full 24hrs in but there seems to be a difference in the reporting.
My miner is reporting AVG 6.5 but the pool is reporting 4.5 up to 5.0 Hashrate.
Is there an additional config needed for the T9
Thank you
1) Is your T9 damaged, only 6.5TH?
2) And you are only looking at Hashrate (1d / 1hr/ 5min / 1min), correct?
Don't think it is damaged pops sometimes over 7TH on BTC or antpool. Yes on the 1d.
Welcome Edhhr127,
studio_mining was right to ask about the state of your device. A T9 with proper power should be pulling ~10.5TH, and I have seen some reported up toward 12.5TH. So, regardless of what you getting on BTC or Antpool, it seems something is amiss with your miner. Were I to speculate wildly, I would guess that only two of your hashboards are working.
The next couple questions I would ask are:
-Are all hashboards connected and showing on your miner's 'Miner Status' page? Are all showing all of their ASICs?
-What power supply are you using?
-On your miner, same 'Miner Status' page, do you have a significant number of Rejected shares, versus Accepted? If the former is more than say 1% of the later, then there is certainly something to investigate.
Happy hashing!
Thank you for the Welcome,
I am using bitmain recommended PSU
I am below 1% but maybe a bit high at 0.6%
All boards running.
Did the firmware update when I first got the unit.
So just if other come up with an issues;
Right now powered down and an resetting.
(Edit)
Thank you for the help, replaced power supply. Fault must have just shown after power down and reboot to new pool.
Show Posts
