Latest posts of: MigaoMiner

Show Posts
Pages: [1]

on: March 24, 2020, 01:58:01 AM

not sure how the speed running on S9 and T9+, but these old model miner fan seems running longer than S9K. BTW, i just changed the fan. Thanks miners.

on: March 20, 2020, 01:50:18 AM

Hi all Miners, I experienced a few miners S9K starting loosing its fan. FAN 1 to be exact. Anyone of u have the same experienced? Is only 7 months old. MM

on: November 06, 2019, 04:40:51 AM

I have the same problem for some Controller card. Bring to technician, load new binary file using NAND programmer n replaced the old NAND. back to live ..

on: October 14, 2019, 02:33:55 AM

It need experienced.. i have attended the repair course and i appreciate more to those technician after that class.. Sometimes the tester show certain ASIC malfunction, it is not that ASIC problem, but dry join for a resistor. Enjoy

on: September 10, 2019, 12:19:36 AM

i thought all new firmware from bitmain will closed its SSH port? With this, miner still possible to be hacked?

on: September 06, 2019, 12:00:07 AM

try solve your fan problem 1st. U are having 4 Fans... replace with a new fan n try again.

on: August 05, 2019, 11:59:27 PM

May 2019 firmware will stop hashing when no fan detected or even will not boo upon detect low fan rpm. Others firmware - not sure.

on: August 05, 2019, 01:10:32 AM

careful, i have done according to the web. Was working fine for few days. Can detect rpm etc. Few days later Controller board not able to detect the rpm, checked it burned that specific signal. Not even can detect 12cm fan anymore. Just sharing my experience only. It could be i have done something not right. regards, MM

on: July 24, 2019, 02:57:28 AM

Dear All, I have connected the USB to serial converter to the S9 controller board. Connected via serial connection and got bunch of messages. Weird is i cannot login, and the system just continue to reboot n ended at Fan detection. What ever i type seems not received by the Controller board. Appreciate kind advise. regards, MM

on: July 18, 2019, 01:09:35 AM

I encountered quite same problem but with L3+ when i installed the 4th hash board, the hashing rate (RT) will slowly decreased to 0. Changed everything n lastly found the controller board having problem. In detail what causing the Controller board behaving like this unknown; as i never bother to send for repair due to cost. regards, MM

on: July 18, 2019, 12:57:54 AM

Hi Technak, Do you think reinstall bitmain firmware using SSH will enable back "SD port"? Anyway i can PM you please? regards, MM

on: July 16, 2019, 08:38:53 AM

Hi Technak, Your write up is to enable SSH port for firmware version may 2019. May i know how you solve the issue of "2 led light up when changing the J4 jumper during SD card flashing" ? thanks MM

Pages: [1]