So i have an update, i took the advice and downloaded t-rex, hooked everything up

asoon as i run the command --mt 1

my gpu #4 crashes (1080ti) and then follwing up my rig crashes

so this would be a problem with my card correct>? is there anyway to fix this.. would pumping the powerlimit up to 80-100% help??
or should i leave it at 0 and do --mt 1,1,1,0,1,1

thanks for all your help so far
James

I have 2 power supplies, I don't think the power supply is the issue, i think i have a 600W and a 1000W, The problem is when overclocking, I can obviously see all the stats , so my power consumption goes from 170W to 1000W when i only increase my card by 25MHz from 500 - 525 MHz via overclocking

I cannot just use ETHPillenlarger because it crashes my rig (causes the 1080ti to go over 1000W and then automatically crashes)

here is a link to my console
https://ibb.co/6Brq91k

it goes from 175W to 1000W when i try get 0.2 more MH/s.. which obviously overloads something

Hi thereSo i recently bought a mining rig with the following configuration, running on windows with MSI Afterburner and nicehash miner2x 1080ti

2x 1080

1x 2070

1x 3060

after days of trying to figure out why it kept crashing/ or immediately crashing after enabling ETHLargementPill, i went and manually on each card spent time overclocking by +25 a piece

i noticed on the 1080ti, Asoon as i went past around +500 the Power shot from 175W to 1000W and crashed the rig

I assume the same happens when i enable EthEnlargerPill that it OC'd or boosts the card memory past 500MHz and then causes power to spike to 1000W and crash the rid or PowerSupply

any suggestions on why this might be happening, It sucks not running EthEnlargerPill and OC'ing my rig properly>>