I bought a 200gh unit and after roughly 24 hours of mining I noticed the rig turned itself on and off, then the hash rate bounces from 84-96mh but never any higher.
Temperature reads below the parameters set by Vision Man. All settings are at what they recommend. I turned the unit off, let it sit for about an hour, turned it back on, and it still has the same issue.
I reset to defaults, got everything reconfigured in terms of Chip Frequency, Miner Count, etc. It still has the exact same issue!
The unit is hard wired with wireless disabled.
Any help would be greatly appreciated, and thank you for your time.

Miner Count: 16
Asic Count: 10
Frequency: 1300
Fan1: 2760
Fan2: 0
Fan3: 0
Temp1: -1
Temp2: 52
Temp3: -1
DH(%) 1.2526
NMW: 237
Firmware: 20131110
Controller: 2013110865